Contact Information

Dr. Jeffrey Roux
Assistant Professor

Department of Mechanical Engineering
University of Mississippi

225 Carrier Hall
University, MS 38677-1848

662-915-5375

Education

  • Doctor of Mechanical Engineering
    University of Tennessee
  • Masters in Mechanical Engineering
    University of Tennessee
  • Bachelors in Mechanical Engineering
    Louisiana State University

Teaching and Industrial

  • Assistant Professor: January 1981 - 1986
  • Associate Professor; 1986, -Present
  • Professor of Mechanical Engineering and Chairman- 1986-2007, conducting research and teaching heat transfer and thermal science courses.
  • Northrop Services, Inc., Huntsville, Alabama (1970-1972) member of technical staff, senior engineer
  • ARO, Inc., Tullahoma, Tennessee (1972-1979, research engineer; 1979-1980, Senior Lead Engineer, 1980-1981, Section Supervisor of Research Section - 12 member section)

Publications

  • “Effect of Fiber Volume Fraction in Fiber Reinforcement Compaction in Resin Injection Pultrusion,” N. Shakya, J. A. Roux, and A. L. Jeswani, Journal of Polymers and Polymer Composites, Vol. 24, No. 1, January, 2016, pp. 1 – 13.
  • “Constant Velocity Combustion Parametric Ideal Scramjet Cycle Analysis,” J. A. Roux and L. S. Tiruveedula, Journal of Thermphysics and Heat Transfer, Vol. 30, No. 3, July/September, 2016, pp. 698-704. http://dx.doi.org/10.2514/1.T4792
  • “Fiber Volume Fraction Influence on Fiber Compaction in Tapered Resin Injection Pultrusion,” N. B. Masuram, J. A. Roux and A. L. Jeswani, Journal of Applied Composite Materials, Vol. 23, No. 3, June, 2016, pp. 421-442. doi: 10.1007/s10443-015-9466-z
  • “Constant Velocity Combustion Scramjet Cycle Analysis for Non-Ideal Mass Flow Rate,” J. A. Roux and L. S. Tiruveedula, Journal of Thermal Science and Engineering Progress, Vol. 2, June 2017, pp. 8-14. doi: 10.1016/j.tsep.2017.03.003
  • “Pull Speed Influence on Fiber Compaction and Wetout in Tapered Resin Injection Pultrusion,” N. B. Masuram, J. A. Roux and A. L. Jeswani, Journal Polymers and Polymer Composites, Vol. 25, No. 6, June 2017, pp. 419 - 433